Simple Performance Tester for Superpave Mix Design: First-Article Development and Evaluation (2003) / Chapter Skim
Currently Skimming:
Pages 100-107
The Chapter Skim interface presents what we've algorithmically identified as the most significant single chunk of text within every page in the chapter.
Select key terms on the right to highlight them within pages of the chapter.
From page 101... ...
B-2 1. INTRODUCTION This Appendix documents the laboratory methods used in the preparation and testing of specimens for the mixture testing component of the first-article evaluation.
|
From page 102... ...
B-4 approximately 17 percent. Volumetric properties for the mixtures are provided in Table 3.
|
From page 103... ...
B-6 Table 4. Binder Properties for Evaluation Mixtures.
|
From page 104... ...
B-8 accordance with AASHTO T314. An Interlaken compactor meeting the requirements of AASHTO T314 and AASHTO PP35 was used to prepare the gyratory specimens.
|
From page 105... ...
B-10 Figure 3. Portable Core Drilling Machine and Stand.
|
From page 106... ...
B-12 All coring and sawing was done using water to cool the cutting tools. After all cutting was complete, the bulk specific gravity of the finished specimen was determined in accordance with AASHTO T166 by first measuring the immersed mass, then the saturated surface dry mass, and finally the dry mass.
|
From page 107... ...
B-14 Table 7. Evaluation Testing P rogram .
|
Key Terms
This material may be derived from roughly machine-read images, and so is provided only to facilitate research.
More
information on Chapter Skim is available.