Skip to main content

Currently Skimming:


Pages 10-33

The Chapter Skim interface presents what we've algorithmically identified as the most significant single chunk of text within every page in the chapter.
Select key terms on the right to highlight them within pages of the chapter.


From page 11...
... 11 This appendix provides a link to Standard Specifications for some of the agencies (Colorado, Iowa, Kansas, Louisiana, Minnesota, Missouri, Montana, and Pennsylvania) participating in this study.
From page 12...
... 12 COLORADO DOT Standard Specification (2019) : https://www.codot.gov/business/designsupport/cdot-constructionspecifications/2019-construction-specifications/2019-specs-book.
From page 13...
... 13 IOWA DOT Standard Specification (2015) : https://iowadot.gov/erl/current/GS/content/2310.htm.
From page 14...
... 14 Used with the permission of the Iowa DOT.
From page 15...
... 15 Used with the permission of the Iowa DOT.
From page 16...
... 16 Used with the permission of the Iowa DOT.
From page 17...
... 17 Used with the permission of the Iowa DOT.
From page 18...
... 18 KANSAS DOT Standard Specification (2007) : https://www.ksdot.org/Assets/wwwksdotorg/bureaus/burConsMain/ specprov/2007/pdf/07-05004.pdf.
From page 19...
... 19 LOUISIANA DOTD Standard Specification – ultra-thin whitetopping is not included in current Standards. The following Special Provision was provided by the Louisiana DOTD.
From page 20...
... 20 Table 1 Test Requirements Slump TR 207 Less than or equal to 4 inches (100 mm) without water reducers and 8 inches (200 mm)
From page 21...
... 21 The contractor shall furnish equipment and employ methods that produce an acceptable riding surface in accordance with Subsection 601.11. Pavement tie-in areas with surface deviations in excess of 0.25 inch in 10 feet (6 mm in 3 m)
From page 22...
... 22 MINNESOTA DOT Standard Specification (2018) : http://www.dot.state.mn.us/pre-letting/spec/2018/2018-spec-book-final.pdf.
From page 23...
... 23 Image courtesy Fillmore County, Minnesota
From page 24...
... 24 Image courtesy of Fillmore County, MN
From page 25...
... 25 Image courtesy Fillmore County, Minnesota
From page 26...
... 26 MISSOURI DOT Standard Specification (2020) : https://www.modot.org/sites/default/files/documents/2020%20Missouri%20Standard%20Specific%20-%20MHTC %20%28April%202021%29.pdf.
From page 27...
... 27 Restrictions. Do not place concrete when air temperature exceeds 90 degrees F
From page 28...
... 28 actual thickness measured with the specified thickness. The variation is determined to the nearest 1 mm as deficient variation.
From page 29...
... 29 Used with the permission of the Montana DOT.
From page 30...
... 30 Used with the permission of the Montana DOT.
From page 31...
... 31 Used with the permission of the Montana DOT.
From page 32...
... 32 PENNSYLVANIA DOT Standard Specification (2020) : http://www.dot.state.pa.us/public/PubsForms/Publications/Pub_408/ 408_2020/408_2020_2/408_2020_2.pdf.
From page 33...
... 33 Used with the permission of the Pennsylvania DOT.

Key Terms



This material may be derived from roughly machine-read images, and so is provided only to facilitate research.
More information on Chapter Skim is available.